Digital PS-2000B Series Guide d'installation télécharger pdf

-1-

This CF Card unit (PSB-CFU01) is made by Pro-face for use with PS-2000B Series

Built-in computers, hereafter referred to as the "PS-B".

PSB-CFU01

Installation Guide

Corresponding Products : PS-2000B Series Units

(All product names that appear in this guide are the trademarks of their respec-

tive companies)

Pro-face: Digital Electronics Corporation (in Japan and other countries)

MS-DOS, Windows: Microsoft Corporation (USA)

To Prevent Accidents

• Since the PSB-CFU01 is a precision instrument, be sure it is neither hit by nor

pressed strongly against another object.

• The PSB-CFU01 is designed to use only CF Cards whose rated voltage is DC 5V.

Be sure not to use any other type of CF Card.

• Be sure water, liquids or metal particles are not allowed to enter the unit. Any of

these may cause either a breakdown or an electrical shock.

• Be sure to check that the PS-B’s power is disconnected before

installing the unit, in order to prevent an electrical shock.

• Do not attempt to modify or open the PSB-CFU01, due to the

dangers of shock and fire.

• When installing the PSB-CFU01, be sure to read the following

“3. Installation” section’s information completely to insure that

the unit is correctly installed.

WARNINGS

• Do not place or store this unit in a location where there is direct sunlight, excessive

heat, dust or vibration.

• Do not store or operate this unit near chemicals, or where there are chemical fumes.

• Do not allow anyone other than service staff trained by Pro-face to perform mainte-

nance or make adjustments to this unit.

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Installation Guide

-1-This CF Card unit (PSB-CFU01) is made by Pro-face for use with PS-2000B SeriesBuilt-in computers, hereafter referred to as the "PS-B".PSB

Page 2 - Hardware Specifications

-2-The environment specifications given here are for a unit installed in aPS-B.Please check that the following items are included in your package. PS

Page 3 - CF Card Unit Settings

-3-The PSB-CFU01 is factory set for use as the PS-B's Slave drive, however, if the userdesires, this setting can be changed so that the PSB-CFU01

Page 4 - WARNINGS

-4-Since the PSB-CFU01 is a precision instrument, be sure it is neither hitby nor pressed strongly against another object.Cover1)Lay the PS-B unit on

Page 5

-5-2)Tilt the maintenance cover up asshown by arrow a and lift it out inthe direction shown by arrow b (seediagram).(Go to step 3.)abIDE I/F 1Fron

Page 6 - CAUTIONS

-6-CF Card Handling4CAUTIONSCF Card Handling• The following CF Cards are manufactured by the Digital ElectronicsCorporation and are recommended for us

Page 7

-7- Inserting the CF Card1) Turn OFF the PS-B unit's main power, and uncover the PS-B's cover/mainte-nance cover. For the procedures

Page 8 - 4 Hardware Setup

-8-Please be aware that Digital Electronics Corporation shall not be held liable by the userfor any damages, losses, or third party claims arising fro