Digital PS-2000B Series Guide d'installation télécharger pdf (Page 11)

5 Installing the PS-B

1) Use the four (4) attachment screws included in the PS-B’s packing box to

attach the mounting brackets to the PS-B main unit. Be careful that each

bracket is attached to the correct side.

Use the following procedures to install the PS-B into a solid panel.



 External Output Signal (DOUT Port)

Be sure to operate the unit within its maximum load current. If the maxi-

mum load current exceeds this range, a malfunction or PS-B damage may

occur.

Rated Load Voltage DC12V to DC24V

Maximum Load Current

100mA/point

Maximum Voltage Drop between Terminals 1.5V (at 100mA load current)

Isolation Method Via photocoupler

DOUT0(+), DOUT1(+)

DOUT2(+), DOUT3(+)

(Interface Circuit) (Connection Example)

+5V

Cable

D-sub 25 pin Connector

4.7kΩ

PC357

SSTA06

DC12 to DC24V

Load

DOUT0(-), DOUT1(-)

DOUT2(-), DOUT3(-)

When Installing the PS-B vertically

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Digital PS-2000B Series Guide d'installation Page 11